speedo needles?
Moderator: Octane2097
- ThyRosh
- CB-Uk User
- Posts: 54
- Joined: Thu Jun 04, 2009 4:57 pm
speedo needles?
i got a set of calibra dials and im thinkin of swappin the needles over, cuz the calibra ones are clear plastic and look sick with the blue LEDs behind um, plus im upgrading my dials to plasma, anyone ever swapped there needles for any others? just wondering if they will work, cant see why not as long as there not too long or short?
Bags Are For Groceries.
- PRICER
- CB-Uk User
- Posts: 3510
- Joined: Sun May 10, 2009 9:21 pm
- Location: ludlow shropshire
Re: speedo needles?
should do... they're both vauxhall, you would just have to make sure that they dont catch i guess
TURBO LAG IS JUST FOREPLAY
2.0 16v GSI SPORT TWIN WEBER 45'S AND KENT CAMS :]
2.0 16v GSI SPORT TWIN WEBER 45'S AND KENT CAMS :]
- ThyRosh
- CB-Uk User
- Posts: 54
- Joined: Thu Jun 04, 2009 4:57 pm
Re: speedo needles?
that what im thinkin, might as well get the goodies off the calibra before its scrapped lol, whats the speedo like to get out in the corsa?
Bags Are For Groceries.
- PRICER
- CB-Uk User
- Posts: 3510
- Joined: Sun May 10, 2009 9:21 pm
- Location: ludlow shropshire
Re: speedo needles?
piece of piss mate, theirs 3 or 4 screws to hold the surround around the steering column, then three screws that hold the plastic surround around the dials, then when thats out the way, theirs just two screws and two clips that hold the dials in place, and depending if yours is cable driven then its got a speedo clip on the back of it aswell.
TURBO LAG IS JUST FOREPLAY
2.0 16v GSI SPORT TWIN WEBER 45'S AND KENT CAMS :]
2.0 16v GSI SPORT TWIN WEBER 45'S AND KENT CAMS :]
- ThyRosh
- CB-Uk User
- Posts: 54
- Joined: Thu Jun 04, 2009 4:57 pm
Re: speedo needles?
ah sweet sounds just like the calibras, which was pretty easy, sweet ill be rippin that out when the dials turn up =] cheers
Bags Are For Groceries.
- PRICER
- CB-Uk User
- Posts: 3510
- Joined: Sun May 10, 2009 9:21 pm
- Location: ludlow shropshire
Re: speedo needles?
oh also, when you got the corsa dials apart, slowly prise the speedo needle up and over its bottom stop and then wait until the spring settles, then when it does settle mark that point with a small dot from a pen, then when you pull the needle off you have a reference as to where to put the new needle back on to so as that when its the other side of the stop it will be reading the right speed again,
TURBO LAG IS JUST FOREPLAY
2.0 16v GSI SPORT TWIN WEBER 45'S AND KENT CAMS :]
2.0 16v GSI SPORT TWIN WEBER 45'S AND KENT CAMS :]
- ThyRosh
- CB-Uk User
- Posts: 54
- Joined: Thu Jun 04, 2009 4:57 pm
Re: speedo needles?
ah i get ya, cuz when its on the stop, its still under a bit of pressure? so if i was to fit it over the stop straight away ill be doin 60 but only driving at 50? am i on the right lines lol
Bags Are For Groceries.
- PRICER
- CB-Uk User
- Posts: 3510
- Joined: Sun May 10, 2009 9:21 pm
- Location: ludlow shropshire
Re: speedo needles?
yea your on the right lines mate orr what you can do is do what i did and plug the dash in without its cover on so you can still move the needle then drive through those flashy speed things and when your doing 30 mph say, push the needle on so it reads 30 LOL i had to do this with one set of dials i had but then i managed to get hold of another set with white dials on and they were set up propperly so yea,
TURBO LAG IS JUST FOREPLAY
2.0 16v GSI SPORT TWIN WEBER 45'S AND KENT CAMS :]
2.0 16v GSI SPORT TWIN WEBER 45'S AND KENT CAMS :]
-
- CB-Uk Newbie
- Posts: 4
- Joined: Thu May 06, 2010 9:57 am
Re: speedo needles?
Speedo needles nothing but it is speedo sensor .These are mostly used in vehicle to mesure the speed.Now most of the vehicle uses digital speedo meter.
[url=http://www.r4ds.co.uk/][r4i sdhc[/url]
- PRICER
- CB-Uk User
- Posts: 3510
- Joined: Sun May 10, 2009 9:21 pm
- Location: ludlow shropshire
Re: speedo needles?
what are you going on about?
TURBO LAG IS JUST FOREPLAY
2.0 16v GSI SPORT TWIN WEBER 45'S AND KENT CAMS :]
2.0 16v GSI SPORT TWIN WEBER 45'S AND KENT CAMS :]
- PRICER
- CB-Uk User
- Posts: 3510
- Joined: Sun May 10, 2009 9:21 pm
- Location: ludlow shropshire
Re: speedo needles?
hey how have you got on changing the needles?
TURBO LAG IS JUST FOREPLAY
2.0 16v GSI SPORT TWIN WEBER 45'S AND KENT CAMS :]
2.0 16v GSI SPORT TWIN WEBER 45'S AND KENT CAMS :]