engine help please,
Moderator: Octane2097
- james_ballantine
- CB-Uk Newbie
- Posts: 5
- Joined: Sat Apr 09, 2011 8:40 pm
engine help please,
was wondering if anyone could shine a bit of light on this for me, will the 1.2 16v engine from a corsa c (fuel injected) fit into my 1.2 16v corsa b? (carburetor) like will the looms fit to my car? nd shizz like that,
- c16se corsa
- CB-Uk User
- Posts: 271
- Joined: Thu Jan 27, 2011 3:29 pm
- Location: Pontefract
Re: engine help please,
why?
If its not bodged then its not "propper"
Bike carb project
http://forums.corsa-b.co.uk/viewtopic.php?f=81&t=19528
Bike carb project
http://forums.corsa-b.co.uk/viewtopic.php?f=81&t=19528
- james_ballantine
- CB-Uk Newbie
- Posts: 5
- Joined: Sat Apr 09, 2011 8:40 pm
Re: engine help please,
Why? Cause I'm gona stick the corsa c engine in my corsa b. Well was thinking about doing it. Cause my engine is about to kick the bucket. got a 1.2 engine out of a c for free. Just had con rods broke. Already found out that it's a big job to change looms etc. But can use the head of it so all's sweet,
-
- CB-Uk Newbie
- Posts: 24
- Joined: Sun Nov 06, 2011 8:37 pm
Re: engine help please,
you have a carb on your corsa? Did you fit that yourself or is it a single point injection?
- james_ballantine
- CB-Uk Newbie
- Posts: 5
- Joined: Sat Apr 09, 2011 8:40 pm
Re: engine help please,
Just the original single point injection, that's why I was asking if it was possible to fit the corsa c engine which has a fuel rail and multi point injection. But seems to be a hassle to wire up the electronic throttle,
-
- CB-Uk Newbie
- Posts: 24
- Joined: Sun Nov 06, 2011 8:37 pm
Re: engine help please,
Can't you just fit the inlet manifold from your engine? I can't see there being much of a difference, I think they're both the same Suzuki based engine.
- james_ballantine
- CB-Uk Newbie
- Posts: 5
- Joined: Sat Apr 09, 2011 8:40 pm
Re: engine help please,
Turns out there is no difference. My inlet manifold fitted right on. Dont know why i didnt think of that in the first place. Cheers for that btw. Any idea where I can get con rods that won't cost an arm and a leg?